Blind Mark BMWK Manuel d'instructions télécharger pdf

Step 1

Compare the Blind Mark™ locator outside

perimeter to the out side of the electrical box

you are using. Electrical boxes vary so this will

show you where to make your cut.(on the line

inside or outside the line)

Step 2

Place Blind Mark™ target, with the arrow

pointing up, in electrical box. If you have a

multi-gang box you install the targets at each

end of the box.

Step 3

With the target is installed in the box you cover

the box up with the drywall. Position your

drywall in the exact location and fasten it top

and bottom.

Step 4

With the arrow on the target locator facing up,

pass the locator across the area in which the

target is located. The locator will Þ nd the target

and snap in place. Do not force the locator

into position. Hold the sides of the locator and

let it jump to Þ nal position on its own. If the

locator does not look plum rotate right or left

till it appears plum. Then you take your pencil

and mark around the locator, outlining the box

perimeter.

Step 5

Remove the locator from the drywall. Cut out

the drywall using your mark as a guide. If you

are using a hand saw, keep in mind, the cut on

the side where the stud is must be a shallow

cut. Multiple tools can then be used (hand or

electric) to cut the drywall.

Remove the drywall cut out and Blind Mark™

target. Finish screwing down the drywall.

And you’re Done!!!

Six easy steps to use the Blind Mark™ Target/Locator.

Résumé du contenu

Page 1

Step 1Compare the Blind Mark™ locator outside perimeter to the out side of the electrical box you are using. Electrical boxes vary so this will show y

Commentaires sur ces manuels

Pas de commentaire

Blind Mark BMWK Manuel d'instructions

Naviguer en ligne ou télécharger Manuel d'instructions pour Non Blind Mark BMWK. Blind Mark BMWK Instructions / Assembly Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels